Strong Match — 95.1% match
based on chemical composition and mechanical property overlap.
AISI 1015 and SAE J403 1017 (SAE J403:2014) are both steel grades.
Both fall under the Carbon Steel category.
AISI 1015 is typically used for case hardened pins, bushes, light gears, while SAE J403 1017 is commonly used for chemistry-only grade; product scope as listed in the composition notes.
AISI 1015 is defined under AISI, originating from United States, while SAE J403 1017 is defined under SAE International, originating from United States.
As per chemical composition, AISI 1015 vs SAE J403 1017 is a 95.1% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 95.1%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
AISI 1015
SAE J403 1017
Tensile Strength
380–530 MPa
Not specified
Elongation
≥22%
Not specified
Hardness
≤131 HB
Not specified
Typical Applications
AISI 1015
Case hardened pins, bushes, light gears
SAE J403 1017
Chemistry-only grade; product scope as listed in the composition notes
Can AISI 1015 Be Substituted With SAE J403 1017?
AISI 1015 and SAE J403 1017 overlap closely enough on chemistry and mechanical properties that SAE J403 1017 is often considered as a substitute for AISI 1015 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between AISI 1015 and SAE J403 1017?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can AISI 1015 be substituted with SAE J403 1017?
AISI 1015 and SAE J403 1017 overlap closely enough on chemistry and mechanical properties that SAE J403 1017 is often considered as a substitute for AISI 1015 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.