Close Alternative — 78.9% match
based on chemical composition and mechanical property overlap.
ASTM A240/A240M S32053 (ASTM A240/A240M:2025) and JIS G4305 SUS836L (JIS G4305:2012) are both steel grades.
Both fall under the Stainless Steel category.
ASTM A240/A240M S32053 is typically used for pressure vessels and general applications (plate, sheet and strip), while JIS G4305 SUS836L is commonly used for cold-rolled stainless steel plates, sheet and strip.
ASTM A240/A240M S32053 is defined under ASTM International, originating from United States, while JIS G4305 SUS836L is defined under Japanese Industrial Standards (JIS), originating from Japan.
As per chemical composition, ASTM A240/A240M S32053 vs JIS G4305 SUS836L is a 80.8% match.
As per mechanical properties, the match is 75%.
Combined, this makes them a close alternative overall at 78.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
ASTM A240/A240M S32053
JIS G4305 SUS836L
Tensile Strength
>=640 MPa
>=640 MPa
Yield Strength
>=295 MPa
>=275 MPa
Elongation
>=40%
>=40%
Hardness
<=217 HB
<=217 HB
Condition
Plate, sheet and strip; yield by 0.2 percent offset
Solution heat treated plate and strip; 0.2 percent proof strength applies only when specified by the purchaser
Typical Applications
ASTM A240/A240M S32053
Pressure vessels and general applications (plate, sheet and strip)
JIS G4305 SUS836L
Cold-rolled stainless steel plates, sheet and strip
Can ASTM A240/A240M S32053 Be Substituted With JIS G4305 SUS836L?
ASTM A240/A240M S32053 and JIS G4305 SUS836L are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between ASTM A240/A240M S32053 and JIS G4305 SUS836L?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can ASTM A240/A240M S32053 be substituted with JIS G4305 SUS836L?
ASTM A240/A240M S32053 and JIS G4305 SUS836L are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.