Close Alternative — 74.9% match
based on chemical composition and mechanical property overlap.
ASTM A959 S30615 (ASTM A959:2011) and JIS G4305 SUSXM15J1 (JIS G4305:2012) are both steel grades.
Both fall under the Stainless Steel category.
ASTM A959 S30615 is typically used for wrought stainless steel products; recommended composition limits for adoption by product standards (clause 1.1), while JIS G4305 SUSXM15J1 is commonly used for cold-rolled stainless steel plates, sheet and strip.
ASTM A959 S30615 is defined under ASTM International, originating from United States, while JIS G4305 SUSXM15J1 is defined under Japanese Industrial Standards (JIS), originating from Japan.
As per chemical composition, ASTM A959 S30615 vs JIS G4305 SUSXM15J1 is a 74.9% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 74.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
ASTM A959 S30615
JIS G4305 SUSXM15J1
Tensile Strength
Not specified
>=520 MPa
Yield Strength
Not specified
>=205 MPa
Elongation
Not specified
>=40%
Hardness
Not specified
<=207 HB
Condition
Not specified
Solution heat treated plate and strip; 0.2 percent proof strength applies only when specified by the purchaser
Typical Applications
ASTM A959 S30615
Wrought stainless steel products; recommended composition limits for adoption by product standards (clause 1.1)
JIS G4305 SUSXM15J1
Cold-rolled stainless steel plates, sheet and strip
Key Differences
ASTM A959 S30615 specifies Al which is not specified for JIS G4305 SUSXM15J1.
Can ASTM A959 S30615 Be Substituted With JIS G4305 SUSXM15J1?
ASTM A959 S30615 and JIS G4305 SUSXM15J1 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between ASTM A959 S30615 and JIS G4305 SUSXM15J1?
ASTM A959 S30615 specifies Al which is not specified for JIS G4305 SUSXM15J1.
Can ASTM A959 S30615 be substituted with JIS G4305 SUSXM15J1?
ASTM A959 S30615 and JIS G4305 SUSXM15J1 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.