Close Alternative — 81.5% match
based on chemical composition and mechanical property overlap.
BS 970 (Part 1) 210M15 (BS 970 (Part 1):1983) and SAE J403 1126 (SAE J403:2014) are both steel grades.
Both fall under the Free Machining Steel category.
BS 970 (Part 1) 210M15 is typically used for case hardening steel for mechanical and allied engineering purposes (table 11 mechanical properties)., while SAE J403 1126 is commonly used for chemistry-only grade; product scope as listed in the composition notes.
BS 970 (Part 1) 210M15 is defined under British Standards (BS), originating from United Kingdom, while SAE J403 1126 is defined under SAE International, originating from United States.
As per chemical composition, BS 970 (Part 1) 210M15 vs SAE J403 1126 is a 81.5% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 81.5%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Typical Applications
BS 970 (Part 1) 210M15
Case hardening steel for mechanical and allied engineering purposes (Table 11 mechanical properties).
SAE J403 1126
Chemistry-only grade; product scope as listed in the composition notes
Can BS 970 (Part 1) 210M15 Be Substituted With SAE J403 1126?
BS 970 (Part 1) 210M15 and SAE J403 1126 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between BS 970 (Part 1) 210M15 and SAE J403 1126?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can BS 970 (Part 1) 210M15 be substituted with SAE J403 1126?
BS 970 (Part 1) 210M15 and SAE J403 1126 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.