Strong Match — 92.7% match
based on chemical composition and mechanical property overlap.
BS 970 EN5A (BS 970:1955) and BS 970 (Part 3) 080A30 (BS 970 (Part 3):1991) are both steel grades.
Both fall under the Carbon Steel category.
BS 970 EN5A is typically used for axles, crankshafts, connecting rods, while BS 970 (Part 3) 080A30 is commonly used for bright cold finished bars (cold drawn, turned or precision ground) for general engineering purposes, in straight lengths; carbon and carbon manganese steel (table 13).
BS 970 EN5A is defined under British Standards (BS), originating from United Kingdom, while BS 970 (Part 3) 080A30 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, BS 970 EN5A vs BS 970 (Part 3) 080A30 is a 92.7% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 92.7%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Typical Applications
BS 970 EN5A
Axles, crankshafts, connecting rods
BS 970 (Part 3) 080A30
Bright cold finished bars (cold drawn, turned or precision ground) for general engineering purposes, in straight lengths; carbon and carbon manganese steel (Table 13)
Can BS 970 EN5A Be Substituted With BS 970 (Part 3) 080A30?
BS 970 EN5A and BS 970 (Part 3) 080A30 overlap closely enough on chemistry and mechanical properties that BS 970 (Part 3) 080A30 is often considered as a substitute for BS 970 EN5A in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between BS 970 EN5A and BS 970 (Part 3) 080A30?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can BS 970 EN5A be substituted with BS 970 (Part 3) 080A30?
BS 970 EN5A and BS 970 (Part 3) 080A30 overlap closely enough on chemistry and mechanical properties that BS 970 (Part 3) 080A30 is often considered as a substitute for BS 970 EN5A in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.