Strong Match — 86.4% match
based on chemical composition and mechanical property overlap.
DIN 17210 15Cr3 (DIN 17210:1986) and SAE J404 5115 (SAE J404:2000) are both steel grades.
Both fall under the Alloy Steel category.
DIN 17210 15Cr3 is typically used for low-alloy chromium case-hardening (carburizing) steel; gears, shafts, pins, and machine components requiring a hard wear-resistant carburized surface with a tough core, while SAE J404 5115 is commonly used for chemistry-only alloy steel grade; see the composition notes for product scope.
DIN 17210 15Cr3 is defined under Deutsches Institut fur Normung (DIN), originating from Germany, while SAE J404 5115 is defined under SAE International, originating from United States.
As per chemical composition, DIN 17210 15Cr3 vs SAE J404 5115 is a 86.4% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 86.4%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
DIN 17210 15Cr3
SAE J404 5115
Tensile Strength
490-640 MPa
Not specified
Yield Strength
295 MPa min
Not specified
Elongation
18% min
Not specified
Hardness
143-187 HB
Not specified
Typical Applications
DIN 17210 15Cr3
Low-alloy chromium case-hardening (carburizing) steel; gears, shafts, pins, and machine components requiring a hard wear-resistant carburized surface with a tough core
SAE J404 5115
Chemistry-only alloy steel grade; see the composition notes for product scope
Can DIN 17210 15Cr3 Be Substituted With SAE J404 5115?
DIN 17210 15Cr3 and SAE J404 5115 overlap closely enough on chemistry and mechanical properties that SAE J404 5115 is often considered as a substitute for DIN 17210 15Cr3 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between DIN 17210 15Cr3 and SAE J404 5115?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can DIN 17210 15Cr3 be substituted with SAE J404 5115?
DIN 17210 15Cr3 and SAE J404 5115 overlap closely enough on chemistry and mechanical properties that SAE J404 5115 is often considered as a substitute for DIN 17210 15Cr3 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.