Strong Match — 98.8% match
based on chemical composition and mechanical property overlap.
EN 10083-1 2C50 (EN 10083-1:1991) and EN 10083-1 3C50 (EN 10083-1:1991) are both steel grades.
Both fall under the Carbon Steel category.
EN 10083-1 2C50 is typically used for quenched and tempered machine parts; non alloy steels also normalized (clause 1), while EN 10083-1 3C50 is commonly used for quenched and tempered machine parts; non alloy steels also normalized (clause 1).
EN 10083-1 2C50 is defined under European Standard (EN), originating from Europe, while EN 10083-1 3C50 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10083-1 2C50 vs EN 10083-1 3C50 is a 98.2% match.
As per mechanical properties, the match is 100%.
Combined, this makes them a strong match overall at 98.8%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10083-1 2C50
EN 10083-1 3C50
Condition
Quenched and tempered, ruling section d <= 16 mm
Quenched and tempered, ruling section d <= 16 mm
Elongation
13% min
13% min
Hardness
Soft annealed: 217 HB max
Soft annealed: 217 HB max
Tensile Strength
750 to 900 MPa
750 to 900 MPa
Yield Strength
520 MPa min
520 MPa min
Typical Applications
EN 10083-1 2C50
Quenched and tempered machine parts; non alloy steels also normalized (clause 1)
EN 10083-1 3C50
Quenched and tempered machine parts; non alloy steels also normalized (clause 1)
Can EN 10083-1 2C50 Be Substituted With EN 10083-1 3C50?
EN 10083-1 2C50 and EN 10083-1 3C50 overlap closely enough on chemistry and mechanical properties that EN 10083-1 3C50 is often considered as a substitute for EN 10083-1 2C50 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10083-1 2C50 and EN 10083-1 3C50?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10083-1 2C50 be substituted with EN 10083-1 3C50?
EN 10083-1 2C50 and EN 10083-1 3C50 overlap closely enough on chemistry and mechanical properties that EN 10083-1 3C50 is often considered as a substitute for EN 10083-1 2C50 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.