Minimal Match — 47.9% match
based on chemical composition and mechanical property overlap.
EN 10083-3 37CrS4 (EN 10083-3:2006) and UNI 11234 100Cr6 (UNI 11234:2007) are both steel grades.
Both fall under the Alloy Steel category.
EN 10083-3 37CrS4 is typically used for quenched and tempered, flame or induction hardened machine parts (clause 1), while UNI 11234 100Cr6 is commonly used for ball bearings,roller bearings,needle bearings,dies,punches,gauges,wear resistant components.
EN 10083-3 37CrS4 is defined under European Standard (EN), originating from Europe, while UNI 11234 100Cr6 is defined under Ente Nazionale Italiano di Unificazione (UNI), originating from Italy.
As per chemical composition, EN 10083-3 37CrS4 vs UNI 11234 100Cr6 is a 71.8% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 47.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10083-3 37CrS4
UNI 11234 100Cr6
Condition
Quenched and tempered (+QT), ruling section d <= 16 mm
Not specified
Elongation
11% min
10-14 %
Hardness
Soft annealed (+A): 235 HBW max
60-64 HRC
Tensile Strength
950 to 1150 MPa
750-1000 MPa
Yield Strength
750 MPa min
400-600 MPa
Typical Applications
EN 10083-3 37CrS4
Quenched and tempered, flame or induction hardened machine parts (clause 1)
Can EN 10083-3 37CrS4 Be Substituted With UNI 11234 100Cr6?
EN 10083-3 37CrS4 and UNI 11234 100Cr6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10083-3 37CrS4 and UNI 11234 100Cr6?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10083-3 37CrS4 be substituted with UNI 11234 100Cr6?
EN 10083-3 37CrS4 and UNI 11234 100Cr6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.