Close Alternative — 83.7% match
based on chemical composition and mechanical property overlap.
EN 10084 C15E (EN 10084:2008) and BS 970 (Part 1) 040A10 (BS 970 (Part 1):1991) are both steel grades.
Both fall under the Carbon Steel category.
EN 10084 C15E is typically used for case hardened machine parts: carburized or carbonitrided, then hardened (clause 3.1), while BS 970 (Part 1) 040A10 is commonly used for used for bolts, studs, shafts, brackets, fabricated components, and general engineering parts..
EN 10084 C15E is defined under European Standard (EN), originating from Europe, while BS 970 (Part 1) 040A10 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, EN 10084 C15E vs BS 970 (Part 1) 040A10 is a 83.7% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 83.7%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10084 C15E
BS 970 (Part 1) 040A10
Condition
Soft annealed
Not specified
Hardness
Soft annealed: 143 HB max
Not specified
Typical Applications
EN 10084 C15E
Case hardened machine parts: carburized or carbonitrided, then hardened (clause 3.1)
BS 970 (Part 1) 040A10
Used for bolts, studs, shafts, brackets, fabricated components, and general engineering parts.
Key Differences
EN 10084 C15E specifies P, S, Si which are not specified for BS 970 (Part 1) 040A10.
Can EN 10084 C15E Be Substituted With BS 970 (Part 1) 040A10?
EN 10084 C15E and BS 970 (Part 1) 040A10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10084 C15E and BS 970 (Part 1) 040A10?
EN 10084 C15E specifies P, S, Si which are not specified for BS 970 (Part 1) 040A10.
Can EN 10084 C15E be substituted with BS 970 (Part 1) 040A10?
EN 10084 C15E and BS 970 (Part 1) 040A10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.