Strong Match — 100% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X1CrNi25-21 (EN 10088-1:2014) and EN 10088-2 X1CrNi25-21 (EN 10088-2:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X1CrNi25-21 is defined under European Standard (EN), originating from Europe, while EN 10088-2 X1CrNi25-21 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-1 X1CrNi25-21 vs EN 10088-2 X1CrNi25-21 is a 100% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 100%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X1CrNi25-21
EN 10088-2 X1CrNi25-21
Tensile Strength
Not specified
470-670 MPa
Yield Strength
Not specified
>=200 MPa
Elongation
Not specified
>=40%
Condition
Not specified
Solution annealed (+AT), hot rolled plate, up to 75 mm thick; Yield Strength is Rp0.2 (transverse), Elongation is A80 for under 3 mm thick
Typical Applications
EN 10088-1 X1CrNi25-21
Not documented
EN 10088-2 X1CrNi25-21
General purposes, hot or cold rolled sheet/plate and strip
Can EN 10088-1 X1CrNi25-21 Be Substituted With EN 10088-2 X1CrNi25-21?
EN 10088-1 X1CrNi25-21 and EN 10088-2 X1CrNi25-21 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X1CrNi25-21 is often considered as a substitute for EN 10088-1 X1CrNi25-21 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-1 X1CrNi25-21 and EN 10088-2 X1CrNi25-21?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-1 X1CrNi25-21 be substituted with EN 10088-2 X1CrNi25-21?
EN 10088-1 X1CrNi25-21 and EN 10088-2 X1CrNi25-21 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X1CrNi25-21 is often considered as a substitute for EN 10088-1 X1CrNi25-21 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.