EN 10088-1 X4CrNiMo16-5-1 vs EN 10088-2 X4CrNiMo16-5-1
Strong Match — 100% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X4CrNiMo16-5-1 (EN 10088-1:2014) and EN 10088-2 X4CrNiMo16-5-1 (EN 10088-2:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X4CrNiMo16-5-1 is defined under European Standard (EN), originating from Europe, while EN 10088-2 X4CrNiMo16-5-1 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-1 X4CrNiMo16-5-1 vs EN 10088-2 X4CrNiMo16-5-1 is a 100% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 100%.
Frequently Compared With EN 10088-1 X4CrNiMo16-5-1:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X4CrNiMo16-5-1
EN 10088-2 X4CrNiMo16-5-1
Tensile Strength
Not specified
840-1100 MPa
Yield Strength
Not specified
>=660 MPa
Elongation
Not specified
>=14%
Condition
Not specified
Quenched and tempered (+QT840), hot rolled plate, up to 75 mm thick
Typical Applications
EN 10088-1 X4CrNiMo16-5-1
Not documented
EN 10088-2 X4CrNiMo16-5-1
General purposes, hot or cold rolled sheet/plate and strip
Can EN 10088-1 X4CrNiMo16-5-1 Be Substituted With EN 10088-2 X4CrNiMo16-5-1?
EN 10088-1 X4CrNiMo16-5-1 and EN 10088-2 X4CrNiMo16-5-1 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X4CrNiMo16-5-1 is often considered as a substitute for EN 10088-1 X4CrNiMo16-5-1 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-1 X4CrNiMo16-5-1 and EN 10088-2 X4CrNiMo16-5-1?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-1 X4CrNiMo16-5-1 be substituted with EN 10088-2 X4CrNiMo16-5-1?
EN 10088-1 X4CrNiMo16-5-1 and EN 10088-2 X4CrNiMo16-5-1 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X4CrNiMo16-5-1 is often considered as a substitute for EN 10088-1 X4CrNiMo16-5-1 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.