Close Alternative — 83.4% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X50CrMoV15 (EN 10088-1:2023) and EN 10088-3 X55CrMo14 (EN 10088-3:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X50CrMoV15 is defined under European Standard (EN), originating from Europe, while EN 10088-3 X55CrMo14 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-1 X50CrMoV15 vs EN 10088-3 X55CrMo14 is a 83.4% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 83.4%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X50CrMoV15
EN 10088-3 X55CrMo14
Tensile Strength
Not specified
<=950 MPa
Hardness
Not specified
<=280 HB
Condition
Not specified
Annealed (+A), conditions 1C, 1E, 1D, 1X, 1G and 2D, thickness or diameter up to 100 mm; hardness for guidance only
Typical Applications
EN 10088-1 X50CrMoV15
Not documented
EN 10088-3 X55CrMo14
General purposes, semi-finished products, bars, rods, wire, sections and bright products
Can EN 10088-1 X50CrMoV15 Be Substituted With EN 10088-3 X55CrMo14?
EN 10088-1 X50CrMoV15 and EN 10088-3 X55CrMo14 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-1 X50CrMoV15 and EN 10088-3 X55CrMo14?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-1 X50CrMoV15 be substituted with EN 10088-3 X55CrMo14?
EN 10088-1 X50CrMoV15 and EN 10088-3 X55CrMo14 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.