Strong Match — 87.5% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X6CrNi17-1 (EN 10088-1:2023) and IS 5522 X07Cr17 (IS 5522:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X6CrNi17-1 is defined under European Standard (EN), originating from Europe, while IS 5522 X07Cr17 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10088-1 X6CrNi17-1 vs IS 5522 X07Cr17 is a 87.5% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 87.5%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X6CrNi17-1
IS 5522 X07Cr17
Tensile Strength
Not specified
>=450 MPa
Yield Strength
Not specified
>=205 MPa
Elongation
Not specified
>=20%
Hardness
Not specified
<=183 HB
Condition
Not specified
Annealed/softened
Typical Applications
EN 10088-1 X6CrNi17-1
Not documented
IS 5522 X07Cr17
Utensils
Can EN 10088-1 X6CrNi17-1 Be Substituted With IS 5522 X07Cr17?
EN 10088-1 X6CrNi17-1 and IS 5522 X07Cr17 overlap closely enough on chemistry and mechanical properties that IS 5522 X07Cr17 is often considered as a substitute for EN 10088-1 X6CrNi17-1 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-1 X6CrNi17-1 and IS 5522 X07Cr17?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-1 X6CrNi17-1 be substituted with IS 5522 X07Cr17?
EN 10088-1 X6CrNi17-1 and IS 5522 X07Cr17 overlap closely enough on chemistry and mechanical properties that IS 5522 X07Cr17 is often considered as a substitute for EN 10088-1 X6CrNi17-1 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.