Strong Match — 91.8% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X8CrNiS18-9 (EN 10088-1:2023) and IS 5522 X07Cr18Ni9 (IS 5522:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X8CrNiS18-9 is defined under European Standard (EN), originating from Europe, while IS 5522 X07Cr18Ni9 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10088-1 X8CrNiS18-9 vs IS 5522 X07Cr18Ni9 is a 91.8% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 91.8%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X8CrNiS18-9
IS 5522 X07Cr18Ni9
Tensile Strength
Not specified
>=515 MPa
Yield Strength
Not specified
>=205 MPa
Elongation
Not specified
>=40%
Hardness
Not specified
<=201 HB
Condition
Not specified
Annealed/softened
Typical Applications
EN 10088-1 X8CrNiS18-9
Not documented
IS 5522 X07Cr18Ni9
Utensils
Key Differences
EN 10088-1 X8CrNiS18-9 specifies Cu which is not specified for IS 5522 X07Cr18Ni9.
Can EN 10088-1 X8CrNiS18-9 Be Substituted With IS 5522 X07Cr18Ni9?
EN 10088-1 X8CrNiS18-9 and IS 5522 X07Cr18Ni9 overlap closely enough on chemistry and mechanical properties that IS 5522 X07Cr18Ni9 is often considered as a substitute for EN 10088-1 X8CrNiS18-9 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-1 X8CrNiS18-9 and IS 5522 X07Cr18Ni9?
EN 10088-1 X8CrNiS18-9 specifies Cu which is not specified for IS 5522 X07Cr18Ni9.
Can EN 10088-1 X8CrNiS18-9 be substituted with IS 5522 X07Cr18Ni9?
EN 10088-1 X8CrNiS18-9 and IS 5522 X07Cr18Ni9 overlap closely enough on chemistry and mechanical properties that IS 5522 X07Cr18Ni9 is often considered as a substitute for EN 10088-1 X8CrNiS18-9 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.