EN 10088-2 X1CrNiMoCuN25-25-5 vs ASTM A240/A240M N08932
Close Alternative — 70.5% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X1CrNiMoCuN25-25-5 (EN 10088-2:2014) and ASTM A240/A240M N08932 (ASTM A240/A240M:2025) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X1CrNiMoCuN25-25-5 is typically used for general purposes, hot or cold rolled sheet/plate and strip, while ASTM A240/A240M N08932 is commonly used for pressure vessels and general applications (plate, sheet and strip).
EN 10088-2 X1CrNiMoCuN25-25-5 is defined under European Standard (EN), originating from Europe, while ASTM A240/A240M N08932 is defined under ASTM International, originating from United States.
As per chemical composition, EN 10088-2 X1CrNiMoCuN25-25-5 vs ASTM A240/A240M N08932 is a 89.1% match.
As per mechanical properties, the match is 33.3%.
Combined, this makes them a close alternative overall at 70.5%.
Frequently Compared With EN 10088-2 X1CrNiMoCuN25-25-5:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X1CrNiMoCuN25-25-5
ASTM A240/A240M N08932
Tensile Strength
600-800 MPa
>=600 MPa
Yield Strength
>=290 MPa
>=305 MPa
Elongation
>=40%
>=40%
Condition
Solution annealed (+AT), hot rolled plate, up to 75 mm thick; Yield Strength is Rp0.2 (transverse), Elongation is A80 for under 3 mm thick
Plate, sheet and strip; yield by 0.2 percent offset
Typical Applications
EN 10088-2 X1CrNiMoCuN25-25-5
General purposes, hot or cold rolled sheet/plate and strip
ASTM A240/A240M N08932
Pressure vessels and general applications (plate, sheet and strip)
Can EN 10088-2 X1CrNiMoCuN25-25-5 Be Substituted With ASTM A240/A240M N08932?
EN 10088-2 X1CrNiMoCuN25-25-5 and ASTM A240/A240M N08932 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-2 X1CrNiMoCuN25-25-5 and ASTM A240/A240M N08932?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-2 X1CrNiMoCuN25-25-5 be substituted with ASTM A240/A240M N08932?
EN 10088-2 X1CrNiMoCuN25-25-5 and ASTM A240/A240M N08932 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.