EN 10088-2 X2CrMnNiN17-7-5 vs ASTM A240/A240M S20153
Close Alternative — 71.2% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X2CrMnNiN17-7-5 (EN 10088-2:2014) and ASTM A240/A240M S20153 (ASTM A240/A240M:2025) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X2CrMnNiN17-7-5 is typically used for general purposes, hot or cold rolled sheet/plate and strip, while ASTM A240/A240M S20153 is commonly used for pressure vessels and general applications (plate, sheet and strip).
EN 10088-2 X2CrMnNiN17-7-5 is defined under European Standard (EN), originating from Europe, while ASTM A240/A240M S20153 is defined under ASTM International, originating from United States.
As per chemical composition, EN 10088-2 X2CrMnNiN17-7-5 vs ASTM A240/A240M S20153 is a 90.1% match.
As per mechanical properties, the match is 33.3%.
Combined, this makes them a close alternative overall at 71.2%.
Frequently Compared With EN 10088-2 X2CrMnNiN17-7-5:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X2CrMnNiN17-7-5
ASTM A240/A240M S20153
Tensile Strength
650-850 MPa
>=655 MPa
Yield Strength
>=300 MPa
>=310 MPa
Elongation
>=45%
>=45%
Condition
Solution annealed (+AT), cold rolled strip, up to 8 mm thick; Yield Strength is Rp0.2 (transverse), Elongation is A80 for under 3 mm thick
Plate, sheet and strip; yield by 0.2 percent offset
Hardness
Not specified
<=241 HB
Typical Applications
EN 10088-2 X2CrMnNiN17-7-5
General purposes, hot or cold rolled sheet/plate and strip
ASTM A240/A240M S20153
Pressure vessels and general applications (plate, sheet and strip)
Can EN 10088-2 X2CrMnNiN17-7-5 Be Substituted With ASTM A240/A240M S20153?
EN 10088-2 X2CrMnNiN17-7-5 and ASTM A240/A240M S20153 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-2 X2CrMnNiN17-7-5 and ASTM A240/A240M S20153?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-2 X2CrMnNiN17-7-5 be substituted with ASTM A240/A240M S20153?
EN 10088-2 X2CrMnNiN17-7-5 and ASTM A240/A240M S20153 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.