Strong Match — 88.5% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X5CrNiN19-9 (EN 10088-2:2014) and EN 10088-1 X5CrNi18-10 (EN 10088-1:2023) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X5CrNiN19-9 is defined under European Standard (EN), originating from Europe, while EN 10088-1 X5CrNi18-10 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-2 X5CrNiN19-9 vs EN 10088-1 X5CrNi18-10 is a 88.5% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 88.5%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X5CrNiN19-9
EN 10088-1 X5CrNi18-10
Tensile Strength
500-750 MPa
Not specified
Yield Strength
>=290 MPa
Not specified
Elongation
>=40%
Not specified
Condition
Solution annealed (+AT), cold rolled strip, up to 8 mm thick; Yield Strength is Rp0.2 (transverse), Elongation is A80 for under 3 mm thick
Not specified
Typical Applications
EN 10088-2 X5CrNiN19-9
General purposes, hot or cold rolled sheet/plate and strip
EN 10088-1 X5CrNi18-10
Not documented
Can EN 10088-2 X5CrNiN19-9 Be Substituted With EN 10088-1 X5CrNi18-10?
EN 10088-2 X5CrNiN19-9 and EN 10088-1 X5CrNi18-10 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X5CrNi18-10 is often considered as a substitute for EN 10088-2 X5CrNiN19-9 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-2 X5CrNiN19-9 and EN 10088-1 X5CrNi18-10?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-2 X5CrNiN19-9 be substituted with EN 10088-1 X5CrNi18-10?
EN 10088-2 X5CrNiN19-9 and EN 10088-1 X5CrNi18-10 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X5CrNi18-10 is often considered as a substitute for EN 10088-2 X5CrNiN19-9 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.