Close Alternative — 78.8% match
based on chemical composition and mechanical property overlap.
EN 10088-3 X6CrMoNb17-1 (EN 10088-3:2014) and EN 10088-1 X6CrMoS17 (EN 10088-1:2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-3 X6CrMoNb17-1 is defined under European Standard (EN), originating from Europe, while EN 10088-1 X6CrMoS17 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-3 X6CrMoNb17-1 vs EN 10088-1 X6CrMoS17 is a 78.8% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 78.8%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-3 X6CrMoNb17-1
EN 10088-1 X6CrMoS17
Tensile Strength
480-680 MPa
Not specified
Yield Strength
>=300 MPa
Not specified
Elongation
>=15%
Not specified
Hardness
<=200 HB
Not specified
Condition
Annealed (+A), conditions 1C, 1E, 1D, 1X, 1G and 2D, thickness or diameter up to 50 mm; Yield Strength is Rp0.2, Elongation is A (longitudinal), hardness for guidance only
Not specified
Typical Applications
EN 10088-3 X6CrMoNb17-1
General purposes, semi-finished products, bars, rods, wire, sections and bright products
EN 10088-1 X6CrMoS17
Not documented
Key Differences
EN 10088-3 X6CrMoNb17-1 specifies N, Nb which are not specified for EN 10088-1 X6CrMoS17.
Can EN 10088-3 X6CrMoNb17-1 Be Substituted With EN 10088-1 X6CrMoS17?
EN 10088-3 X6CrMoNb17-1 and EN 10088-1 X6CrMoS17 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-3 X6CrMoNb17-1 and EN 10088-1 X6CrMoS17?
EN 10088-3 X6CrMoNb17-1 specifies N, Nb which are not specified for EN 10088-1 X6CrMoS17.
Can EN 10088-3 X6CrMoNb17-1 be substituted with EN 10088-1 X6CrMoS17?
EN 10088-3 X6CrMoNb17-1 and EN 10088-1 X6CrMoS17 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.