Related Material — 69.9% match
based on chemical composition and mechanical property overlap.
IS 11169 (Part 1) 35C14BT (IS 11169 (Part 1):2022) and EN 10084 16MnCrB5 (EN 10084:2008) are both steel grades.
Both fall under the Alloy Steel category.
IS 11169 (Part 1) 35C14BT is typically used for cold heading and cold extrusion of parts that are quenched and tempered; the standard covers bars, wire rods and wires of 2 to 100 mm (clause 1.1, annex c), while EN 10084 16MnCrB5 is commonly used for case hardened machine parts: carburized or carbonitrided, then hardened (clause 3.1).
IS 11169 (Part 1) 35C14BT is defined under Bureau of Indian Standards (IS), originating from India, while EN 10084 16MnCrB5 is defined under European Standard (EN), originating from Europe.
As per chemical composition, IS 11169 (Part 1) 35C14BT vs EN 10084 16MnCrB5 is a 73.8% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a related material overall at 69.9%.
Frequently Compared With IS 11169 (Part 1) 35C14BT:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 11169 (Part 1) 35C14BT
EN 10084 16MnCrB5
Tensile Strength, cold drawn, annealed and skin passed (+AR+C+AC+LC)
<=680 MPa (over 5 to 40 mm)
Not specified
Condition
Not specified
Soft annealed
Hardenability
Not specified
+H band at 1.5 mm from the quenched end: 39 to 47 HRC
Hardness
Not specified
Soft annealed: 207 HB max
Typical Applications
IS 11169 (Part 1) 35C14BT
Cold heading and cold extrusion of parts that are quenched and tempered; the standard covers bars, wire rods and wires of 2 to 100 mm (clause 1.1, Annex C)
EN 10084 16MnCrB5
Case hardened machine parts: carburized or carbonitrided, then hardened (clause 3.1)
Key Differences
IS 11169 (Part 1) 35C14BT specifies Cu which is not specified for EN 10084 16MnCrB5.
Can IS 11169 (Part 1) 35C14BT Be Substituted With EN 10084 16MnCrB5?
IS 11169 (Part 1) 35C14BT and EN 10084 16MnCrB5 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between IS 11169 (Part 1) 35C14BT and EN 10084 16MnCrB5?
IS 11169 (Part 1) 35C14BT specifies Cu which is not specified for EN 10084 16MnCrB5.
Can IS 11169 (Part 1) 35C14BT be substituted with EN 10084 16MnCrB5?
IS 11169 (Part 1) 35C14BT and EN 10084 16MnCrB5 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.