Close Alternative — 84.1% match
based on chemical composition and mechanical property overlap.
IS 1875 Class 1 (IS 1875:1992) and BS 970 (Part 1) 045M10 (BS 970 (Part 1):1983) are both steel grades.
Both fall under the Carbon Steel category.
IS 1875 Class 1 is typically used for billets, blooms, slabs and bars for general engineering forgings, while BS 970 (Part 1) 045M10 is commonly used for case hardening steel for mechanical and allied engineering purposes (table 11 mechanical properties)..
IS 1875 Class 1 is defined under Bureau of Indian Standards (IS), originating from India, while BS 970 (Part 1) 045M10 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, IS 1875 Class 1 vs BS 970 (Part 1) 045M10 is a 84.1% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 84.1%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 1875 Class 1
BS 970 (Part 1) 045M10
Tensile Strength
370 MPa min
Not specified
Yield Strength
200 MPa min
Not specified
Elongation
>=26%
Not specified
Hardness
100 HB min
Not specified
Condition
as rolled or as forged and normalised, ruling section up to 100 mm
Not specified
Normalising Temperature
880-910 °C (for information)
Not specified
Bend Test (if ordered)
32 mm square test piece bent round a 38 mm former without fracture
Not specified
Typical Applications
IS 1875 Class 1
Billets, blooms, slabs and bars for general engineering forgings
BS 970 (Part 1) 045M10
Case hardening steel for mechanical and allied engineering purposes (Table 11 mechanical properties).
Key Differences
IS 1875 Class 1 specifies Si which is not specified for BS 970 (Part 1) 045M10.
Can IS 1875 Class 1 Be Substituted With BS 970 (Part 1) 045M10?
IS 1875 Class 1 and BS 970 (Part 1) 045M10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between IS 1875 Class 1 and BS 970 (Part 1) 045M10?
IS 1875 Class 1 specifies Si which is not specified for BS 970 (Part 1) 045M10.
Can IS 1875 Class 1 be substituted with BS 970 (Part 1) 045M10?
IS 1875 Class 1 and BS 970 (Part 1) 045M10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.