Minimal Match — 53.9% match
based on chemical composition and mechanical property overlap.
IS 1875 Class 1A (IS 1875:1992) and BS 970 (Part 1) 045M10 (BS 970 (Part 1):1991) are both steel grades.
Both fall under the Carbon Steel category.
IS 1875 Class 1A is typically used for billets, blooms, slabs and bars for general engineering forgings, while BS 970 (Part 1) 045M10 is commonly used for case hardening steel (section four).
IS 1875 Class 1A is defined under Bureau of Indian Standards (IS), originating from India, while BS 970 (Part 1) 045M10 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, IS 1875 Class 1A vs BS 970 (Part 1) 045M10 is a 80.8% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 53.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 1875 Class 1A
BS 970 (Part 1) 045M10
Tensile Strength
410 MPa min
430 MPa min
Yield Strength
220 MPa min
Not specified
Elongation
>=25%
18 % min
Hardness
110 HB min
Not specified
Condition
as rolled or as forged and normalised, ruling section up to 100 mm
Case hardened, 19 mm test bar
Normalising Temperature
880-910 °C (for information)
Not specified
Bend Test (if ordered)
32 mm square test piece bent round a 38 mm former without fracture
Not specified
Typical Applications
IS 1875 Class 1A
Billets, blooms, slabs and bars for general engineering forgings
BS 970 (Part 1) 045M10
Case hardening steel (section four)
Key Differences
IS 1875 Class 1A specifies Si, S, P which are not specified for BS 970 (Part 1) 045M10.
Can IS 1875 Class 1A Be Substituted With BS 970 (Part 1) 045M10?
IS 1875 Class 1A and BS 970 (Part 1) 045M10 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between IS 1875 Class 1A and BS 970 (Part 1) 045M10?
IS 1875 Class 1A specifies Si, S, P which are not specified for BS 970 (Part 1) 045M10.
Can IS 1875 Class 1A be substituted with BS 970 (Part 1) 045M10?
IS 1875 Class 1A and BS 970 (Part 1) 045M10 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.