Post Stock Login Register

JIS G4305 SUS890L vs EN 10088-1 X1CrNiMoCuN25-25-5

Close Alternative — 71.5% match based on chemical composition and mechanical property overlap.

JIS G4305 SUS890L (JIS G4305:2012) and EN 10088-1 X1CrNiMoCuN25-25-5 (EN 10088-1:2014) are both steel grades. Both fall under the Stainless Steel category. JIS G4305 SUS890L is defined under Japanese Industrial Standards (JIS), originating from Japan, while EN 10088-1 X1CrNiMoCuN25-25-5 is defined under European Standard (EN), originating from Europe.

As per chemical composition, JIS G4305 SUS890L vs EN 10088-1 X1CrNiMoCuN25-25-5 is a 71.5% match. Mechanical property data is not available for both grades, so this factor could not be scored. Combined, this makes them a close alternative overall at 71.5%.

Frequently Compared With JIS G4305 SUS890L:
GOST 5632 08X18H10 GB/T 3280 06Cr19Ni10 GOST 5632 06Kh23N28 EN 10088-1 1.4301 IS 1570 (Part 7) 12Cr12MoH ASTM A959 .- EN 10088-1 1.4006 EN 10088-1 1.4401 EN 10088-1 1.4845 IS 1570 (Part 7) 11Cr17Ni13W3TiH IS 1570 (Part 7) 12Cr12MoVH IS 1570 (Part 7) 12Cr12Ni2Mo
Match Breakdown
CHEMISTRY MATCH
71.5%
MECHANICAL MATCH
No shared data
OVERALL
71.5%
Specifications
Property JIS G4305 SUS890L EN 10088-1 X1CrNiMoCuN25-25-5
Standard JIS G4305:2012 EN 10088-1:2014
Category Stainless Steel Stainless Steel
C (%) <=0.020 <=0.020
Si (%) <=1.00 <=0.70
Mn (%) <=2.00 <=2.00
P (%) <=0.045 <=0.030
S (%) <=0.030 <=0.010
Ni (%) 23.00-28.00 24.0-27.0
Cr (%) 19.00-23.00 24.0-26.0
Mo (%) 4.00-5.00 4.7-5.7
Cu (%) 1.00-2.00 1.00-2.00
N (%) Not specified 0.17-0.25
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property JIS G4305 SUS890L EN 10088-1 X1CrNiMoCuN25-25-5
Tensile Strength >=490 MPa Not specified
Yield Strength >=215 MPa Not specified
Elongation >=35% Not specified
Hardness <=187 HB Not specified
Condition Solution heat treated plate and strip; 0.2 percent proof strength applies only when specified by the purchaser Not specified
Typical Applications
JIS G4305 SUS890L
Cold-rolled stainless steel plates, sheet and strip
EN 10088-1 X1CrNiMoCuN25-25-5
Not documented
Key Differences
Can JIS G4305 SUS890L Be Substituted With EN 10088-1 X1CrNiMoCuN25-25-5?
JIS G4305 SUS890L and EN 10088-1 X1CrNiMoCuN25-25-5 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
On M-EX Right Now
JIS G4305 SUS890L
0 active listings and RFQs →
EN 10088-1 X1CrNiMoCuN25-25-5
0 active listings and RFQs →
Frequently Asked Questions
What is the difference between JIS G4305 SUS890L and EN 10088-1 X1CrNiMoCuN25-25-5?
EN 10088-1 X1CrNiMoCuN25-25-5 specifies N which is not specified for JIS G4305 SUS890L.
Can JIS G4305 SUS890L be substituted with EN 10088-1 X1CrNiMoCuN25-25-5?
JIS G4305 SUS890L and EN 10088-1 X1CrNiMoCuN25-25-5 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.