Close Alternative — 80.9% match
based on chemical composition and mechanical property overlap.
SAE J404 4023 (SAE J404:2000) and IS 5517 35Mn6Mo3 (IS 5517:1993) are both steel grades.
Both fall under the Alloy Steel category.
SAE J404 4023 is defined under SAE International, originating from United States, while IS 5517 35Mn6Mo3 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, SAE J404 4023 vs IS 5517 35Mn6Mo3 is a 80.9% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 80.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
SAE J404 4023
IS 5517 35Mn6Mo3
Tensile Strength
Not specified
700-850 MPa
Yield Strength (0.2% proof)
Not specified
540 MPa min
Elongation
Not specified
>=18%
Izod Impact
Not specified
55 J min
Hardness (annealed)
Not specified
<=220 HB
Condition
Not specified
Hardened and tempered, ruling section up to 150 mm
Typical Applications
SAE J404 4023
Chemistry-only alloy steel grade; see the composition notes for product scope
IS 5517 35Mn6Mo3
Not documented
Can SAE J404 4023 Be Substituted With IS 5517 35Mn6Mo3?
SAE J404 4023 and IS 5517 35Mn6Mo3 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between SAE J404 4023 and IS 5517 35Mn6Mo3?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can SAE J404 4023 be substituted with IS 5517 35Mn6Mo3?
SAE J404 4023 and IS 5517 35Mn6Mo3 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.