Close Alternative — 83.7% match
based on chemical composition and mechanical property overlap.
SAE J404 8822 (SAE J404:2009) and SAE J404 8620 (SAE J404:2009) are both steel grades.
Both fall under the Alloy Steel category.
SAE J404 8822 is typically used for chemistry-only alloy steel grade; see the composition notes for product scope, while SAE J404 8620 is commonly used for case hardened gears, cams, pins, shafts.
SAE J404 8822 is defined under SAE International, originating from United States, while SAE J404 8620 is defined under SAE International, originating from United States.
As per chemical composition, SAE J404 8822 vs SAE J404 8620 is a 83.7% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 83.7%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Typical Applications
SAE J404 8822
Chemistry-only alloy steel grade; see the composition notes for product scope
SAE J404 8620
Case hardened gears, cams, pins, shafts
Can SAE J404 8822 Be Substituted With SAE J404 8620?
SAE J404 8822 and SAE J404 8620 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between SAE J404 8822 and SAE J404 8620?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can SAE J404 8822 be substituted with SAE J404 8620?
SAE J404 8822 and SAE J404 8620 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.