Minimal Match — 50.2% match
based on chemical composition and mechanical property overlap.
UNS C10200 and UNS C14500 are both copper grades.
Both fall under the Copper Alloys category.
UNS C10200 is defined under Unified Numbering System (UNS), originating from United States, while UNS C14500 is defined under Unified Numbering System (UNS), originating from United States.
As per chemical composition, UNS C10200 vs UNS C14500 is a 75.4% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 50.2%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
UNS C10200
UNS C14500
Yield Strength
~69 MPa (annealed O60)
~205 MPa min (H02 half-hard)
Tensile Strength
~220 MPa (annealed O60)
~260 MPa min (H02 half-hard)
Elongation
~45% (annealed O60)
~8% min (H02 half-hard)
Note
Oxygen-free copper, values for soft annealed condition
Tellurium copper, values for H02 half-hard temper per mill datasheet
Key Differences
UNS C10200 specifies O which is not specified for UNS C14500.
UNS C14500 specifies P, Te which are not specified for UNS C10200.
Can UNS C10200 Be Substituted With UNS C14500?
UNS C10200 and UNS C14500 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between UNS C10200 and UNS C14500?
UNS C10200 specifies O which is not specified for UNS C14500. UNS C14500 specifies P, Te which are not specified for UNS C10200.
Can UNS C10200 be substituted with UNS C14500?
UNS C10200 and UNS C14500 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.