Strong Match — 100% match
based on chemical composition and mechanical property overlap.
AISI 1010 and SAE J403 1010 (SAE J403:2014) are both steel grades.
Both fall under the Carbon Steel category.
AISI 1010 is typically used for tubing, pipe, sheet, structural shapes, wire, while SAE J403 1010 is commonly used for chemistry-only grade; product scope as listed in the composition notes.
AISI 1010 is defined under AISI, originating from United States, while SAE J403 1010 is defined under SAE International, originating from United States.
As per chemical composition, AISI 1010 vs SAE J403 1010 is a 100% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 100%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
AISI 1010
SAE J403 1010
Tensile Strength
340–470 MPa
Not specified
Elongation
≥26%
Not specified
Hardness
≤137 HB
Not specified
Typical Applications
AISI 1010
Tubing, pipe, sheet, structural shapes, wire
SAE J403 1010
Chemistry-only grade; product scope as listed in the composition notes
Can AISI 1010 Be Substituted With SAE J403 1010?
AISI 1010 and SAE J403 1010 overlap closely enough on chemistry and mechanical properties that SAE J403 1010 is often considered as a substitute for AISI 1010 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between AISI 1010 and SAE J403 1010?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can AISI 1010 be substituted with SAE J403 1010?
AISI 1010 and SAE J403 1010 overlap closely enough on chemistry and mechanical properties that SAE J403 1010 is often considered as a substitute for AISI 1010 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.