Close Alternative — 84.9% match
based on chemical composition and mechanical property overlap.
BS 970 (Part 1) 060A78 (BS 970 (Part 1):1991) and BS 970 (Part 1) 060A62 (BS 970 (Part 1):1991) are both steel grades.
Both fall under the Carbon Steel category.
BS 970 (Part 1) 060A78 is typically used for as-rolled, or as-rolled and softened, steel (section two), while BS 970 (Part 1) 060A62 is commonly used for as-rolled, or as-rolled and softened, steel (section two).
BS 970 (Part 1) 060A78 is defined under British Standards (BS), originating from United Kingdom, while BS 970 (Part 1) 060A62 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, BS 970 (Part 1) 060A78 vs BS 970 (Part 1) 060A62 is a 91.4% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 84.9%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Typical Applications
BS 970 (Part 1) 060A78
As-rolled, or as-rolled and softened, steel (section two)
BS 970 (Part 1) 060A62
As-rolled, or as-rolled and softened, steel (section two)
Can BS 970 (Part 1) 060A78 Be Substituted With BS 970 (Part 1) 060A62?
BS 970 (Part 1) 060A78 and BS 970 (Part 1) 060A62 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between BS 970 (Part 1) 060A78 and BS 970 (Part 1) 060A62?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can BS 970 (Part 1) 060A78 be substituted with BS 970 (Part 1) 060A62?
BS 970 (Part 1) 060A78 and BS 970 (Part 1) 060A62 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.