Strong Match — 100% match
based on chemical composition and mechanical property overlap.
EN 10083-1 C22E (EN 10083-1:1996) and EN 10083-1 2C22 (EN 10083-1:1991) are both steel grades.
Both fall under the Carbon Steel category.
EN 10083-1 C22E is typically used for quenched and tempered machine parts; also used normalized (clause 1.1, table 10), while EN 10083-1 2C22 is commonly used for quenched and tempered machine parts; non alloy steels also normalized (clause 1).
EN 10083-1 C22E is defined under European Standard (EN), originating from Europe, while EN 10083-1 2C22 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10083-1 C22E vs EN 10083-1 2C22 is a 100% match.
As per mechanical properties, the match is 100%.
Combined, this makes them a strong match overall at 100%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10083-1 C22E
EN 10083-1 2C22
Condition
Quenched and tempered, ruling section d <= 16 mm
Quenched and tempered, ruling section d <= 16 mm
Elongation
20% min
20% min
Tensile Strength
500 to 650 MPa
500 to 650 MPa
Yield Strength
340 MPa min
340 MPa min
Typical Applications
EN 10083-1 C22E
Quenched and tempered machine parts; also used normalized (clause 1.1, Table 10)
EN 10083-1 2C22
Quenched and tempered machine parts; non alloy steels also normalized (clause 1)
Can EN 10083-1 C22E Be Substituted With EN 10083-1 2C22?
EN 10083-1 C22E and EN 10083-1 2C22 overlap closely enough on chemistry and mechanical properties that EN 10083-1 2C22 is often considered as a substitute for EN 10083-1 C22E in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10083-1 C22E and EN 10083-1 2C22?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10083-1 C22E be substituted with EN 10083-1 2C22?
EN 10083-1 C22E and EN 10083-1 2C22 overlap closely enough on chemistry and mechanical properties that EN 10083-1 2C22 is often considered as a substitute for EN 10083-1 C22E in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.