Close Alternative — 82.2% match
based on chemical composition and mechanical property overlap.
EN 10088-1 1.4401 (EN 10088-1:2014) and BS 970 (Part 1) 316S11 (BS 970 (Part 1):1983) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 1.4401 is typically used for marine, chemical processing, pharmaceutical equipment, while BS 970 (Part 1) 316S11 is commonly used for austenitic stainless and heat resisting steel for mechanical and allied engineering purposes (table 14, with table 15 for the cold drawn condition)..
EN 10088-1 1.4401 is defined under European Standard (EN), originating from Europe, while BS 970 (Part 1) 316S11 is defined under British Standards (BS), originating from United Kingdom.
As per chemical composition, EN 10088-1 1.4401 vs BS 970 (Part 1) 316S11 is a 82.2% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 82.2%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 1.4401
BS 970 (Part 1) 316S11
Tensile Strength
≥520 MPa
Not specified
Yield Strength
≥210 MPa
Not specified
Elongation
≥40%
Not specified
Hardness
≤215 HB
Not specified
Typical Applications
EN 10088-1 1.4401
Marine, chemical processing, pharmaceutical equipment
BS 970 (Part 1) 316S11
Austenitic stainless and heat resisting steel for mechanical and allied engineering purposes (Table 14, with Table 15 for the cold drawn condition).
Key Differences
BS 970 (Part 1) 316S11 specifies P, S which are not specified for EN 10088-1 1.4401.
Can EN 10088-1 1.4401 Be Substituted With BS 970 (Part 1) 316S11?
EN 10088-1 1.4401 and BS 970 (Part 1) 316S11 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-1 1.4401 and BS 970 (Part 1) 316S11?
BS 970 (Part 1) 316S11 specifies P, S which are not specified for EN 10088-1 1.4401.
Can EN 10088-1 1.4401 be substituted with BS 970 (Part 1) 316S11?
EN 10088-1 1.4401 and BS 970 (Part 1) 316S11 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.