Strong Match — 89.4% match
based on chemical composition and mechanical property overlap.
EN 10088-1 X6CrNi23-13 (EN 10088-1:2023) and JIS G4305 SUS309S (JIS G4305:2012) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 X6CrNi23-13 is defined under European Standard (EN), originating from Europe, while JIS G4305 SUS309S is defined under Japanese Industrial Standards (JIS), originating from Japan.
As per chemical composition, EN 10088-1 X6CrNi23-13 vs JIS G4305 SUS309S is a 89.4% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 89.4%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 X6CrNi23-13
JIS G4305 SUS309S
Tensile Strength
Not specified
>=520 MPa
Yield Strength
Not specified
>=205 MPa
Elongation
Not specified
>=40%
Hardness
Not specified
<=187 HB
Condition
Not specified
Solution heat treated plate and strip; 0.2 percent proof strength applies only when specified by the purchaser
Typical Applications
EN 10088-1 X6CrNi23-13
Not documented
JIS G4305 SUS309S
Cold-rolled stainless steel plates, sheet and strip
Key Differences
EN 10088-1 X6CrNi23-13 specifies N which is not specified for JIS G4305 SUS309S.
Can EN 10088-1 X6CrNi23-13 Be Substituted With JIS G4305 SUS309S?
EN 10088-1 X6CrNi23-13 and JIS G4305 SUS309S overlap closely enough on chemistry and mechanical properties that JIS G4305 SUS309S is often considered as a substitute for EN 10088-1 X6CrNi23-13 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-1 X6CrNi23-13 and JIS G4305 SUS309S?
EN 10088-1 X6CrNi23-13 specifies N which is not specified for JIS G4305 SUS309S.
Can EN 10088-1 X6CrNi23-13 be substituted with JIS G4305 SUS309S?
EN 10088-1 X6CrNi23-13 and JIS G4305 SUS309S overlap closely enough on chemistry and mechanical properties that JIS G4305 SUS309S is often considered as a substitute for EN 10088-1 X6CrNi23-13 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.