Close Alternative — 82.1% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X7CrNiAl17-7 (EN 10088-2:2014) and ASTM A959 301 (ASTM A959:2011) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X7CrNiAl17-7 is typically used for general purposes, hot or cold rolled sheet/plate and strip, while ASTM A959 301 is commonly used for wrought stainless steel products; recommended composition limits for adoption by product standards (clause 1.1).
EN 10088-2 X7CrNiAl17-7 is defined under European Standard (EN), originating from Europe, while ASTM A959 301 is defined under ASTM International, originating from United States.
As per chemical composition, EN 10088-2 X7CrNiAl17-7 vs ASTM A959 301 is a 82.1% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 82.1%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X7CrNiAl17-7
ASTM A959 301
Tensile Strength
<=1030 MPa
Not specified
Elongation
>=19%
Not specified
Condition
Solution annealed (+AT, delivery condition), cold rolled strip, up to 8 mm thick
Not specified
Typical Applications
EN 10088-2 X7CrNiAl17-7
General purposes, hot or cold rolled sheet/plate and strip
ASTM A959 301
Wrought stainless steel products; recommended composition limits for adoption by product standards (clause 1.1)
Key Differences
EN 10088-2 X7CrNiAl17-7 specifies Al which is not specified for ASTM A959 301.
ASTM A959 301 specifies N which is not specified for EN 10088-2 X7CrNiAl17-7.
Can EN 10088-2 X7CrNiAl17-7 Be Substituted With ASTM A959 301?
EN 10088-2 X7CrNiAl17-7 and ASTM A959 301 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-2 X7CrNiAl17-7 and ASTM A959 301?
EN 10088-2 X7CrNiAl17-7 specifies Al which is not specified for ASTM A959 301. ASTM A959 301 specifies N which is not specified for EN 10088-2 X7CrNiAl17-7.
Can EN 10088-2 X7CrNiAl17-7 be substituted with ASTM A959 301?
EN 10088-2 X7CrNiAl17-7 and ASTM A959 301 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.