Minimal Match — 35% match
based on chemical composition and mechanical property overlap.
EN 10089 50CrV4 (EN 10089:2002) and IS 3195 55Si7 (IS 3195:1992) are both steel grades.
Both fall under the Spring Steel category.
EN 10089 50CrV4 is typically used for valve springs, high duty coil springs, hand tools, while IS 3195 55Si7 is commonly used for volute and helical springs for railway rolling stock; flats and rounds, springs worked hot and heat-treated (clause 1.1, foreword).
EN 10089 50CrV4 is defined under European Standard (EN), originating from Europe, while IS 3195 55Si7 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10089 50CrV4 vs IS 3195 55Si7 is a 67.6% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 35%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10089 50CrV4
IS 3195 55Si7
Tensile Strength
1100–1300 MPa
Not specified
Yield Strength
≥1000 MPa
Not specified
Elongation
≥8%
Not specified
Hardness
321–375 HB
Not specified
Hardness, annealed
Not specified
<=245 HB
Hardness, untreated (hot rolled)
Not specified
about 270 HB (for guidance only)
Typical Applications
EN 10089 50CrV4
Valve springs, high duty coil springs, hand tools
IS 3195 55Si7
Volute and helical springs for railway rolling stock; flats and rounds, springs worked hot and heat-treated (clause 1.1, foreword)
Key Differences
EN 10089 50CrV4 specifies Cr, V which are not specified for IS 3195 55Si7.
IS 3195 55Si7 specifies P, S which are not specified for EN 10089 50CrV4.
Can EN 10089 50CrV4 Be Substituted With IS 3195 55Si7?
EN 10089 50CrV4 and IS 3195 55Si7 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10089 50CrV4 and IS 3195 55Si7?
EN 10089 50CrV4 specifies Cr, V which are not specified for IS 3195 55Si7. IS 3195 55Si7 specifies P, S which are not specified for EN 10089 50CrV4.
Can EN 10089 50CrV4 be substituted with IS 3195 55Si7?
EN 10089 50CrV4 and IS 3195 55Si7 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.