Minimal Match — 52.6% match
based on chemical composition and mechanical property overlap.
EN 10089 55Si7 (EN 10089:2002) and IS 3195 113C6 (IS 3195:1992) are both steel grades.
Both fall under the Spring Steel category.
EN 10089 55Si7 is typically used for leaf springs, coil springs, torsion bars, while IS 3195 113C6 is commonly used for volute and helical springs for railway rolling stock; flats and rounds, springs worked hot and heat-treated (clause 1.1, foreword).
EN 10089 55Si7 is defined under European Standard (EN), originating from Europe, while IS 3195 113C6 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10089 55Si7 vs IS 3195 113C6 is a 78.9% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 52.6%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10089 55Si7
IS 3195 113C6
Tensile Strength
1000–1200 MPa
Not specified
Yield Strength
≥900 MPa
Not specified
Elongation
≥7%
Not specified
Hardness
285–363 HB
Not specified
Hardness, annealed
Not specified
<=240 HB
Typical Applications
EN 10089 55Si7
Leaf springs, coil springs, torsion bars
IS 3195 113C6
Volute and helical springs for railway rolling stock; flats and rounds, springs worked hot and heat-treated (clause 1.1, foreword)
Can EN 10089 55Si7 Be Substituted With IS 3195 113C6?
EN 10089 55Si7 and IS 3195 113C6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10089 55Si7 and IS 3195 113C6?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10089 55Si7 be substituted with IS 3195 113C6?
EN 10089 55Si7 and IS 3195 113C6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.