Close Alternative — 78.6% match
based on chemical composition and mechanical property overlap.
IS 11169 (Part 1) 16Mn5Cr5 (IS 11169 (Part 1):2022) and SAE J404 5130 (SAE J404:2009) are both steel grades.
Both fall under the Alloy Steel category.
IS 11169 (Part 1) 16Mn5Cr5 is typically used for cold heading and cold extrusion of parts that are case hardened; the standard covers bars, wire rods and wires of 2 to 100 mm (clause 1.1, annex b), while SAE J404 5130 is commonly used for chemistry-only alloy steel grade; see the composition notes for product scope.
IS 11169 (Part 1) 16Mn5Cr5 is defined under Bureau of Indian Standards (IS), originating from India, while SAE J404 5130 is defined under SAE International, originating from United States.
As per chemical composition, IS 11169 (Part 1) 16Mn5Cr5 vs SAE J404 5130 is a 78.6% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a close alternative overall at 78.6%.
Frequently Compared With IS 11169 (Part 1) 16Mn5Cr5:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 11169 (Part 1) 16Mn5Cr5
SAE J404 5130
Hardness, ferrite-pearlite (+FP)
140-187 HB
Not specified
Tensile Strength, annealed (+AC)
<=550 MPa (over 5 to 40 mm)
Not specified
Typical Applications
IS 11169 (Part 1) 16Mn5Cr5
Cold heading and cold extrusion of parts that are case hardened; the standard covers bars, wire rods and wires of 2 to 100 mm (clause 1.1, Annex B)
SAE J404 5130
Chemistry-only alloy steel grade; see the composition notes for product scope
Key Differences
IS 11169 (Part 1) 16Mn5Cr5 specifies Cu which is not specified for SAE J404 5130.
Can IS 11169 (Part 1) 16Mn5Cr5 Be Substituted With SAE J404 5130?
IS 11169 (Part 1) 16Mn5Cr5 and SAE J404 5130 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between IS 11169 (Part 1) 16Mn5Cr5 and SAE J404 5130?
IS 11169 (Part 1) 16Mn5Cr5 specifies Cu which is not specified for SAE J404 5130.
Can IS 11169 (Part 1) 16Mn5Cr5 be substituted with SAE J404 5130?
IS 11169 (Part 1) 16Mn5Cr5 and SAE J404 5130 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.