Strong Match — 99.1% match
based on chemical composition and mechanical property overlap.
IS 11169 (Part 2) X12Cr13 (IS 11169 (Part 2):2023) and EN 10088-2 X12Cr13 (EN 10088-2:2014) are both steel grades.
Both fall under the Stainless Steel category.
IS 11169 (Part 2) X12Cr13 is typically used for cold heading and cold extrusion of stainless steel parts; the standard covers wires, wire rods and bars of 0.8 to 100 mm (clause 1.1, table 14), while EN 10088-2 X12Cr13 is commonly used for general purposes, hot or cold rolled sheet/plate and strip.
IS 11169 (Part 2) X12Cr13 is defined under Bureau of Indian Standards (IS), originating from India, while EN 10088-2 X12Cr13 is defined under European Standard (EN), originating from Europe.
As per chemical composition, IS 11169 (Part 2) X12Cr13 vs EN 10088-2 X12Cr13 is a 98.6% match.
As per mechanical properties, the match is 100%.
Combined, this makes them a strong match overall at 99.1%.
Frequently Compared With IS 11169 (Part 2) X12Cr13:
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 11169 (Part 2) X12Cr13
EN 10088-2 X12Cr13
Reduction of Area, soft annealed (+A)
>=60% (over 5 to 100 mm)
Not specified
Tensile Strength, soft annealed (+A)
<=600 MPa (over 5 to 100 mm)
Not specified
Tensile Strength
Not specified
<=600 MPa
Elongation
Not specified
>=20%
Hardness
Not specified
<=200 HB
Condition
Not specified
Annealed (+A), cold rolled strip, up to 8 mm thick
Typical Applications
IS 11169 (Part 2) X12Cr13
Cold heading and cold extrusion of stainless steel parts; the standard covers wires, wire rods and bars of 0.8 to 100 mm (clause 1.1, Table 14)
EN 10088-2 X12Cr13
General purposes, hot or cold rolled sheet/plate and strip
Can IS 11169 (Part 2) X12Cr13 Be Substituted With EN 10088-2 X12Cr13?
IS 11169 (Part 2) X12Cr13 and EN 10088-2 X12Cr13 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X12Cr13 is often considered as a substitute for IS 11169 (Part 2) X12Cr13 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between IS 11169 (Part 2) X12Cr13 and EN 10088-2 X12Cr13?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can IS 11169 (Part 2) X12Cr13 be substituted with EN 10088-2 X12Cr13?
IS 11169 (Part 2) X12Cr13 and EN 10088-2 X12Cr13 overlap closely enough on chemistry and mechanical properties that EN 10088-2 X12Cr13 is often considered as a substitute for IS 11169 (Part 2) X12Cr13 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.