Strong Match — 94.2% match
based on chemical composition and mechanical property overlap.
JIS G4305 SUS310S (JIS G4305:2012) and EN 10088-1 X8CrNi25-21 (EN 10088-1:2014) are both steel grades.
Both fall under the Stainless Steel category.
JIS G4305 SUS310S is typically used for cold-rolled stainless steel plates, sheet and strip, while EN 10088-1 X8CrNi25-21 is commonly used for furnace parts, heat exchangers, kiln furniture.
JIS G4305 SUS310S is defined under Japanese Industrial Standards (JIS), originating from Japan, while EN 10088-1 X8CrNi25-21 is defined under European Standard (EN), originating from Europe.
As per chemical composition, JIS G4305 SUS310S vs EN 10088-1 X8CrNi25-21 is a 94.2% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 94.2%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
JIS G4305 SUS310S
EN 10088-1 X8CrNi25-21
Tensile Strength
>=520 MPa
Not specified
Yield Strength
>=205 MPa
Not specified
Elongation
>=40%
Not specified
Hardness
<=187 HB
Not specified
Condition
Solution heat treated plate and strip; 0.2 percent proof strength applies only when specified by the purchaser
Not specified
Typical Applications
JIS G4305 SUS310S
Cold-rolled stainless steel plates, sheet and strip
EN 10088-1 X8CrNi25-21
Furnace parts, heat exchangers, kiln furniture
Key Differences
EN 10088-1 X8CrNi25-21 specifies N which is not specified for JIS G4305 SUS310S.
Can JIS G4305 SUS310S Be Substituted With EN 10088-1 X8CrNi25-21?
JIS G4305 SUS310S and EN 10088-1 X8CrNi25-21 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X8CrNi25-21 is often considered as a substitute for JIS G4305 SUS310S in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between JIS G4305 SUS310S and EN 10088-1 X8CrNi25-21?
EN 10088-1 X8CrNi25-21 specifies N which is not specified for JIS G4305 SUS310S.
Can JIS G4305 SUS310S be substituted with EN 10088-1 X8CrNi25-21?
JIS G4305 SUS310S and EN 10088-1 X8CrNi25-21 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X8CrNi25-21 is often considered as a substitute for JIS G4305 SUS310S in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.