Minimal Match — 35% match
based on chemical composition and mechanical property overlap.
AISI 8615 and NF A35-565 100C6 are both steel grades.
Both fall under the Alloy Steel category.
AISI 8615 is typically used for used for gears, shafts, pinions, bushings, transmission parts, and carburized machinery components., while NF A35-565 100C6 is commonly used for ball bearings, roller bearings, bearing races, rollers, precision tools, wear resistant parts.
AISI 8615 is defined under AISI, originating from United States, while NF A35-565 100C6 is defined under Association Francaise de Normalisation (NF), originating from France.
As per chemical composition, AISI 8615 vs NF A35-565 100C6 is a 58.3% match.
As per mechanical properties, the match is 6.3%.
Combined, this makes them a minimal match overall at 35%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
AISI 8615
NF A35-565 100C6
Tensile Strength
700-900 MPa
850-1100 MPa
Yield Strength
500-700 MPa
Not specified
Elongation
14-20%
Not specified
Hardness
180-240 HB
60-66 HRC
Typical Applications
AISI 8615
Used for gears, shafts, pinions, bushings, transmission parts, and carburized machinery components.
AISI 8615 specifies Ni, Mo which are not specified for NF A35-565 100C6.
Can AISI 8615 Be Substituted With NF A35-565 100C6?
AISI 8615 and NF A35-565 100C6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between AISI 8615 and NF A35-565 100C6?
AISI 8615 specifies Ni, Mo which are not specified for NF A35-565 100C6.
Can AISI 8615 be substituted with NF A35-565 100C6?
AISI 8615 and NF A35-565 100C6 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.