BS 970 (Part 1):1983 225M36: 225M36 is a carbon manganese free-cutting steel grade specified in BS 970 Part 1:1983 (Table 6, category 2). Section three of the standard advises that category 1 steels be used for new designs and established designs whenever possible.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Chemical Composition (%)
C
Mn
Si
P
S
0.32-0.40
1.00-1.40
<=0.25
<=0.060
0.20-0.30
More data from BS 970 (Part 1):1983
From the standard
Heat treatment and maximum hardness (through hardening)
Hardening temperature
840-870 deg C
Quenching medium
Oil
Tempering temperature
550-660 deg C
Hardenability test
No hardenability data specified
Softened condition
Not usually supplied in the softened condition
Heat treatment to be given to test bars and to material required in the finally heat treated condition. Note 24: O = oil, W = water. Where oil hardening is specified, either a well-agitated conventional oil or a proven synthetic quenchant may be used. Synthetic quenchants shall not be used for the heat treatment of test bars for material not supplied in the finally heat treated condition.
Source: BS 970 (Part 1):1983, Table 7
Mechanical properties by heat treatment condition
Condition
Limiting ruling section (mm)
Rm (N/mm2)
Re min (N/mm2)
A min (%)
Izod min (ft lbf)
KCV min (J)
Rp0.2 min (N/mm2), when specifically ordered
HB
Q
63
625-775
400
18
25
28
370
179-229
R
13
700-850
480
16
25
28
450
201-255
Values as printed in Table 6 for the limiting ruling section shown. Rp0.2 applies when specifically ordered (note 10). 1 N/mm2 = 1 MPa.
Source: BS 970 (Part 1):1983, Table 6
Comparison with earlier editions
BS 970:1970/72 designation
225M36
BS 970:1955 En No.
None
Appendix D note 47: where a comparison is made the steels are not necessarily equivalent. 'Not listed' means the earlier edition has no entry under this designation.
Source: BS 970 (Part 1):1983, Appendix D
Active BS 970 (Part 1):1983 225M36 Listings on M-EX (For Sale)