Related Material — 61% match
based on chemical composition and mechanical property overlap.
EN 10025-2 E335 (EN 10025-2:2019) and DIN 1654-2 C8C (DIN 1654-2:1989-10) are both steel grades.
EN 10025-2 E335 is classified under Structural Steel, while DIN 1654-2 C8C is classified under Carbon Steel — a different category, which is worth noting alongside the chemistry match below.
EN 10025-2 E335 is typically used for hot rolled products of structural steels, while DIN 1654-2 C8C is commonly used for wire drawing, cold heading, nails.
EN 10025-2 E335 is defined under European Standard (EN), originating from Europe, while DIN 1654-2 C8C is defined under Deutsches Institut fur Normung (DIN), originating from Germany.
As per chemical composition, EN 10025-2 E335 vs DIN 1654-2 C8C is a 91.5% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a related material overall at 61%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-2 E335
DIN 1654-2 C8C
Tensile Strength
570-710 MPa
300–420 MPa
Yield Strength
>=335 MPa
Not specified
Elongation
>=16%
≥30%
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
Not specified
Typical Applications
EN 10025-2 E335
Hot rolled products of structural steels
DIN 1654-2 C8C
Wire drawing, cold heading, nails
Key Differences
Different category: EN 10025-2 E335 is Structural Steel, DIN 1654-2 C8C is Carbon Steel.
EN 10025-2 E335 specifies N which is not specified for DIN 1654-2 C8C.
DIN 1654-2 C8C specifies C, Mn which are not specified for EN 10025-2 E335.
Can EN 10025-2 E335 Be Substituted With DIN 1654-2 C8C?
EN 10025-2 E335 and DIN 1654-2 C8C share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10025-2 E335 and DIN 1654-2 C8C?
Different category: EN 10025-2 E335 is Structural Steel, DIN 1654-2 C8C is Carbon Steel. EN 10025-2 E335 specifies N which is not specified for DIN 1654-2 C8C. DIN 1654-2 C8C specifies C, Mn which are not specified for EN 10025-2 E335.
Can EN 10025-2 E335 be substituted with DIN 1654-2 C8C?
EN 10025-2 E335 and DIN 1654-2 C8C share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.