EN 10025-2:2019 E335 Steel: Specifications & Listings
EN 10025-2:2019 E335: E335: non-alloy structural steel, hot rolled flat and long products, no impact test requirement (steel number 1.0060). Specified in EN 10025-2:2019.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Chemical Composition (%)
P
S
N
<=0.045
<=0.045
<=0.012
Mechanical Properties
Tensile Strength
570-710 MPa
Yield Strength
>=335 MPa
Elongation
>=16%
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
More data from EN 10025-2:2019
From the standard
Yield strength by thickness8 thickness ranges
Thickness (mm)
Yield strength ReH, min (MPa)
up to 16
335
over 16 to 40
325
over 40 to 63
315
over 63 to 80
305
over 80 to 100
295
over 100 to 150
275
over 150 to 200
265
over 200 to 250
255
For plate, strip and wide flats of width 600 mm or more the transverse direction applies.
Source: EN 10025-2:2019, Table 7
Tensile strength by thickness4 thickness ranges
Thickness (mm)
Tensile strength Rm (MPa)
under 3
590 to 770
3 to 100
570 to 710
over 100 to 150
550 to 710
over 150 to 250
540 to 710
Source: EN 10025-2:2019, Table 7
Elongation by thickness5 thickness ranges
Thickness (mm)
Elongation A, longitudinal, min (%)
Elongation A, transverse, min (%)
3 to 40
16
14
over 40 to 63
15
13
over 63 to 100
14
12
over 100 to 150
12
11
over 150 to 250
11
10
Gauge length 5.65 times square root of cross-section area; values for thin products under 3 mm not shown.
Source: EN 10025-2:2019, Table 7 (concluded)
Active EN 10025-2:2019 E335 Listings on M-EX (For Sale)