EN 10025-2:2019 E360 Steel: Specifications & Listings
EN 10025-2:2019 E360: E360: non-alloy structural steel, hot rolled flat and long products, no impact test requirement (steel number 1.0070). Specified in EN 10025-2:2019.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Chemical Composition (%)
P
S
N
<=0.045
<=0.045
<=0.012
Mechanical Properties
Tensile Strength
670-830 MPa
Yield Strength
>=360 MPa
Elongation
>=11%
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
More data from EN 10025-2:2019
From the standard
Yield strength by thickness8 thickness ranges
Thickness (mm)
Yield strength ReH, min (MPa)
up to 16
360
over 16 to 40
355
over 40 to 63
345
over 63 to 80
335
over 80 to 100
325
over 100 to 150
305
over 150 to 200
295
over 200 to 250
285
For plate, strip and wide flats of width 600 mm or more the transverse direction applies.
Source: EN 10025-2:2019, Table 7
Tensile strength by thickness4 thickness ranges
Thickness (mm)
Tensile strength Rm (MPa)
under 3
690 to 900
3 to 100
670 to 830
over 100 to 150
650 to 830
over 150 to 250
640 to 830
Source: EN 10025-2:2019, Table 7
Elongation by thickness5 thickness ranges
Thickness (mm)
Elongation A, longitudinal, min (%)
Elongation A, transverse, min (%)
3 to 40
11
10
over 40 to 63
10
9
over 63 to 100
9
8
over 100 to 150
8
7
over 150 to 250
7
6
Gauge length 5.65 times square root of cross-section area; values for thin products under 3 mm not shown.
Source: EN 10025-2:2019, Table 7 (concluded)
Active EN 10025-2:2019 E360 Listings on M-EX (For Sale)