Minimal Match — 35% match
based on chemical composition and mechanical property overlap.
EN 10025-3 S460NL (EN 10025-3:2019) and CSA G40.21 260W (CSA G40.21-13 (R2023)) are both steel grades.
Both fall under the Structural Steel category.
EN 10025-3 S460NL is defined under European Standard (EN), originating from Europe, while CSA G40.21 260W is defined under Canadian Standards Association (CSA), originating from Canada.
As per chemical composition, EN 10025-3 S460NL vs CSA G40.21 260W is a 59.9% match.
As per mechanical properties, the match is 8.1%.
Combined, this makes them a minimal match overall at 35%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-3 S460NL
CSA G40.21 260W
Tensile Strength
540-720 MPa
410-590 MPa
Yield Strength
>=460 MPa
260 MPa min
Elongation
>=17%
Not specified
Condition
Normalized or normalized rolled (N), nominal thickness up to 16 mm (tensile strength up to 100 mm), Table 4
Not specified
Typical Applications
EN 10025-3 S460NL
Not documented
CSA G40.21 260W
Bridges, buildings, general structural fabrication, storage tanks, older infrastructure projects.
Key Differences
EN 10025-3 S460NL specifies Nb, V, Ni, N which are not specified for CSA G40.21 260W.
Can EN 10025-3 S460NL Be Substituted With CSA G40.21 260W?
EN 10025-3 S460NL and CSA G40.21 260W share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10025-3 S460NL and CSA G40.21 260W?
EN 10025-3 S460NL specifies Nb, V, Ni, N which are not specified for CSA G40.21 260W.
Can EN 10025-3 S460NL be substituted with CSA G40.21 260W?
EN 10025-3 S460NL and CSA G40.21 260W share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.