Close Alternative — 72.2% match
based on chemical composition and mechanical property overlap.
EN 10025-5 S460J2W (EN 10025-5:2019) and EN 10025-5 S420K2W (EN 10025-5:2019) are both steel grades.
Both fall under the Structural Steel (Corten / Weathering) category.
EN 10025-5 S460J2W is defined under European Standard (EN), originating from Europe, while EN 10025-5 S420K2W is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10025-5 S460J2W vs EN 10025-5 S420K2W is a 97.9% match.
As per mechanical properties, the match is 20.6%.
Combined, this makes them a close alternative overall at 72.2%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-5 S460J2W
EN 10025-5 S420K2W
Tensile Strength
530-710 MPa
500-660 MPa
Yield Strength
>=460 MPa
>=420 MPa
Elongation
>=17%
>=19%
Condition
Nominal thickness up to 16 mm for yield, 3 to 100 mm for tensile, 3 to 40 mm for elongation (Lo = 5.65 sqrt(S0), longitudinal); transverse values are lower, see blocks
Nominal thickness up to 16 mm for yield, 3 to 100 mm for tensile, 3 to 40 mm for elongation (Lo = 5.65 sqrt(S0), longitudinal); transverse values are lower, see blocks
Can EN 10025-5 S460J2W Be Substituted With EN 10025-5 S420K2W?
EN 10025-5 S460J2W and EN 10025-5 S420K2W are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10025-5 S460J2W and EN 10025-5 S420K2W?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10025-5 S460J2W be substituted with EN 10025-5 S420K2W?
EN 10025-5 S460J2W and EN 10025-5 S420K2W are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.