Strong Match — 93.1% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X50CrMoV15 (EN 10088-2:2014) and EN 10088-1 X50CrMoV15 (EN 10088-1:2023) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X50CrMoV15 is defined under European Standard (EN), originating from Europe, while EN 10088-1 X50CrMoV15 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-2 X50CrMoV15 vs EN 10088-1 X50CrMoV15 is a 93.1% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 93.1%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X50CrMoV15
EN 10088-1 X50CrMoV15
Tensile Strength
<=850 MPa
Not specified
Elongation
>=12%
Not specified
Hardness
<=280 HB
Not specified
Condition
Annealed (+A), cold rolled strip, up to 8 mm thick
Not specified
Typical Applications
EN 10088-2 X50CrMoV15
General purposes, hot or cold rolled sheet/plate and strip
EN 10088-1 X50CrMoV15
Not documented
Can EN 10088-2 X50CrMoV15 Be Substituted With EN 10088-1 X50CrMoV15?
EN 10088-2 X50CrMoV15 and EN 10088-1 X50CrMoV15 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X50CrMoV15 is often considered as a substitute for EN 10088-2 X50CrMoV15 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-2 X50CrMoV15 and EN 10088-1 X50CrMoV15?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-2 X50CrMoV15 be substituted with EN 10088-1 X50CrMoV15?
EN 10088-2 X50CrMoV15 and EN 10088-1 X50CrMoV15 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X50CrMoV15 is often considered as a substitute for EN 10088-2 X50CrMoV15 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.