Minimal Match — 35% match
based on chemical composition and mechanical property overlap.
EN 10025-2 E295 (EN 10025-2:2019) and ASTM A1008 SS Grade 80 (ASTM A1008) are both steel grades.
Both fall under the Structural Steel category.
EN 10025-2 E295 is typically used for hot rolled products of structural steels, while ASTM A1008 SS Grade 80 is commonly used for cold-rolled high-strength structural steel sheet, higher strength grade; automotive structural/reinforcement components, cold-formed high-strength parts.
EN 10025-2 E295 is defined under European Standard (EN), originating from Europe, while ASTM A1008 SS Grade 80 is defined under ASTM International, originating from United States.
As per chemical composition, EN 10025-2 E295 vs ASTM A1008 SS Grade 80 is a 79.7% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 35%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-2 E295
ASTM A1008 SS Grade 80
Tensile Strength
470-610 MPa
570 MPa min
Yield Strength
>=295 MPa
550 MPa min
Elongation
>=20%
10% min
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
EN 10025-2 E295 specifies N which is not specified for ASTM A1008 SS Grade 80.
ASTM A1008 SS Grade 80 specifies C, Mn, Si which are not specified for EN 10025-2 E295.
Can EN 10025-2 E295 Be Substituted With ASTM A1008 SS Grade 80?
EN 10025-2 E295 and ASTM A1008 SS Grade 80 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10025-2 E295 and ASTM A1008 SS Grade 80?
EN 10025-2 E295 specifies N which is not specified for ASTM A1008 SS Grade 80. ASTM A1008 SS Grade 80 specifies C, Mn, Si which are not specified for EN 10025-2 E295.
Can EN 10025-2 E295 be substituted with ASTM A1008 SS Grade 80?
EN 10025-2 E295 and ASTM A1008 SS Grade 80 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.