EN 10025-2:2019 E295 Steel: Specifications & Listings
EN 10025-2:2019 E295: E295: non-alloy structural steel, hot rolled flat and long products, no impact test requirement (steel number 1.0050). Specified in EN 10025-2:2019.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Chemical Composition (%)
P
S
N
<=0.045
<=0.045
<=0.012
Mechanical Properties
Tensile Strength
470-610 MPa
Yield Strength
>=295 MPa
Elongation
>=20%
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
More data from EN 10025-2:2019
From the standard
Yield strength by thickness8 thickness ranges
Thickness (mm)
Yield strength ReH, min (MPa)
up to 16
295
over 16 to 40
285
over 40 to 63
275
over 63 to 80
265
over 80 to 100
255
over 100 to 150
245
over 150 to 200
235
over 200 to 250
225
For plate, strip and wide flats of width 600 mm or more the transverse direction applies.
Source: EN 10025-2:2019, Table 7
Tensile strength by thickness4 thickness ranges
Thickness (mm)
Tensile strength Rm (MPa)
under 3
490 to 660
3 to 100
470 to 610
over 100 to 150
450 to 610
over 150 to 250
440 to 610
Source: EN 10025-2:2019, Table 7
Elongation by thickness5 thickness ranges
Thickness (mm)
Elongation A, longitudinal, min (%)
Elongation A, transverse, min (%)
3 to 40
20
18
over 40 to 63
19
17
over 63 to 100
18
16
over 100 to 150
16
15
over 150 to 250
15
14
Gauge length 5.65 times square root of cross-section area; values for thin products under 3 mm not shown.
Source: EN 10025-2:2019, Table 7 (concluded)
Active EN 10025-2:2019 E295 Listings on M-EX (For Sale)