Related Material — 65% match
based on chemical composition and mechanical property overlap.
EN 10025-2 E335 (EN 10025-2:2019) and SAE J403 1002 (SAE J403:2009) are both steel grades.
EN 10025-2 E335 is classified under Structural Steel, while SAE J403 1002 is classified under Carbon Steel — a different category, which is worth noting alongside the chemistry match below.
EN 10025-2 E335 is typically used for hot rolled products of structural steels, while SAE J403 1002 is commonly used for chemistry-only grade; product scope as listed in the composition notes.
EN 10025-2 E335 is defined under European Standard (EN), originating from Europe, while SAE J403 1002 is defined under SAE International, originating from United States.
As per chemical composition, EN 10025-2 E335 vs SAE J403 1002 is a 86.5% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a related material overall at 65%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-2 E335
SAE J403 1002
Tensile Strength
570-710 MPa
Not specified
Yield Strength
>=335 MPa
Not specified
Elongation
>=16%
Not specified
Condition
Nominal thickness up to 16 mm (tensile for 3 to 100 mm, elongation for 3 to 40 mm), longitudinal test pieces
Not specified
Typical Applications
EN 10025-2 E335
Hot rolled products of structural steels
SAE J403 1002
Chemistry-only grade; product scope as listed in the composition notes
Key Differences
Different category: EN 10025-2 E335 is Structural Steel, SAE J403 1002 is Carbon Steel.
EN 10025-2 E335 specifies N which is not specified for SAE J403 1002.
SAE J403 1002 specifies C, Mn which are not specified for EN 10025-2 E335.
Can EN 10025-2 E335 Be Substituted With SAE J403 1002?
EN 10025-2 E335 and SAE J403 1002 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10025-2 E335 and SAE J403 1002?
Different category: EN 10025-2 E335 is Structural Steel, SAE J403 1002 is Carbon Steel. EN 10025-2 E335 specifies N which is not specified for SAE J403 1002. SAE J403 1002 specifies C, Mn which are not specified for EN 10025-2 E335.
Can EN 10025-2 E335 be substituted with SAE J403 1002?
EN 10025-2 E335 and SAE J403 1002 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.