Close Alternative — 73.3% match
based on chemical composition and mechanical property overlap.
EN 10025-2 S275 (EN 10025-2:2019) and IS 2062 E165 (IS 2062:2006) are both steel grades.
Both fall under the Structural Steel category.
EN 10025-2 S275 is typically used for structural beams, columns, bridges, general fabrication, while IS 2062 E165 is commonly used for structural work: welded, bolted and riveted structures and general engineering purposes.
EN 10025-2 S275 is defined under European Standard (EN), originating from Europe, while IS 2062 E165 is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10025-2 S275 vs IS 2062 E165 is a 93.3% match.
As per mechanical properties, the match is 33.3%.
Combined, this makes them a close alternative overall at 73.3%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10025-2 S275
IS 2062 E165
Yield Strength
275 MPa min (t<=16mm)
165 MPa (all thicknesses)
Tensile Strength
410-560 MPa
>=290 MPa
Elongation
23% min
>=23%
Impact
Not specified
not required
Typical Applications
EN 10025-2 S275
Structural beams, columns, bridges, general fabrication
IS 2062 E165
Structural work: welded, bolted and riveted structures and general engineering purposes
Key Differences
EN 10025-2 S275 specifies Si which is not specified for IS 2062 E165.
Can EN 10025-2 S275 Be Substituted With IS 2062 E165?
EN 10025-2 S275 and IS 2062 E165 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10025-2 S275 and IS 2062 E165?
EN 10025-2 S275 specifies Si which is not specified for IS 2062 E165.
Can EN 10025-2 S275 be substituted with IS 2062 E165?
EN 10025-2 S275 and IS 2062 E165 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.