Minimal Match — 34.6% match
based on chemical composition and mechanical property overlap.
EN 10028-2 16Mo3 (EN 10028-2:2017) and IS 1570 (Part 7) 10Mo6H (IS 1570 (Part 7):1992) are both steel grades.
Both fall under the Alloy Steel category.
EN 10028-2 16Mo3 is typically used for flat products for pressure purposes, while IS 1570 (Part 7) 10Mo6H is commonly used for boilers, pressure vessels, steam turbines, steam and water piping and other power plant equipment working at elevated temperature.
EN 10028-2 16Mo3 is defined under European Standard (EN), originating from Europe, while IS 1570 (Part 7) 10Mo6H is defined under Bureau of Indian Standards (IS), originating from India.
As per chemical composition, EN 10028-2 16Mo3 vs IS 1570 (Part 7) 10Mo6H is a 52% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 34.6%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10028-2 16Mo3
IS 1570 (Part 7) 10Mo6H
Tensile Strength
440-590 MPa
>=415 MPa
Yield Strength
>=275 MPa
>=205 MPa (0.2 % proof stress)
Elongation
>=22%
>=30%
Condition
Usual delivery condition normalized (+N), nominal thickness up to 16 mm; transverse direction, Yield Strength is ReH, Elongation is A
Tubes, N+T, thickness - (first row of Table 3)
Typical Applications
EN 10028-2 16Mo3
Flat products for pressure purposes
IS 1570 (Part 7) 10Mo6H
Boilers, pressure vessels, steam turbines, steam and water piping and other power plant equipment working at elevated temperature
Key Differences
EN 10028-2 16Mo3 specifies N, Cu, Ni which are not specified for IS 1570 (Part 7) 10Mo6H.
Can EN 10028-2 16Mo3 Be Substituted With IS 1570 (Part 7) 10Mo6H?
EN 10028-2 16Mo3 and IS 1570 (Part 7) 10Mo6H share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between EN 10028-2 16Mo3 and IS 1570 (Part 7) 10Mo6H?
EN 10028-2 16Mo3 specifies N, Cu, Ni which are not specified for IS 1570 (Part 7) 10Mo6H.
Can EN 10028-2 16Mo3 be substituted with IS 1570 (Part 7) 10Mo6H?
EN 10028-2 16Mo3 and IS 1570 (Part 7) 10Mo6H share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.