Strong Match — 94.7% match
based on chemical composition and mechanical property overlap.
EN 10088-2 X2CrTi24 (EN 10088-2:2014) and EN 10088-1 X2CrTi24 (EN 10088-1:2023) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-2 X2CrTi24 is defined under European Standard (EN), originating from Europe, while EN 10088-1 X2CrTi24 is defined under European Standard (EN), originating from Europe.
As per chemical composition, EN 10088-2 X2CrTi24 vs EN 10088-1 X2CrTi24 is a 94.7% match.
Mechanical property data is not available for both grades, so this factor could not be scored.
Combined, this makes them a strong match overall at 94.7%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-2 X2CrTi24
EN 10088-1 X2CrTi24
Tensile Strength
430-630 MPa
Not specified
Condition
Annealed (+A), cold rolled strip, up to 8 mm thick; Elongation is A80 (under 3 mm) or A (3 mm and over), longitudinal and transverse
Not specified
Yield Strength
>=230 MPa
Not specified
Elongation
>=18%
Not specified
Typical Applications
EN 10088-2 X2CrTi24
General purposes, hot or cold rolled sheet/plate and strip
EN 10088-1 X2CrTi24
Not documented
Key Differences
EN 10088-2 X2CrTi24 specifies Ti which is not specified for EN 10088-1 X2CrTi24.
Can EN 10088-2 X2CrTi24 Be Substituted With EN 10088-1 X2CrTi24?
EN 10088-2 X2CrTi24 and EN 10088-1 X2CrTi24 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X2CrTi24 is often considered as a substitute for EN 10088-2 X2CrTi24 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.
What is the difference between EN 10088-2 X2CrTi24 and EN 10088-1 X2CrTi24?
EN 10088-2 X2CrTi24 specifies Ti which is not specified for EN 10088-1 X2CrTi24.
Can EN 10088-2 X2CrTi24 be substituted with EN 10088-1 X2CrTi24?
EN 10088-2 X2CrTi24 and EN 10088-1 X2CrTi24 overlap closely enough on chemistry and mechanical properties that EN 10088-1 X2CrTi24 is often considered as a substitute for EN 10088-2 X2CrTi24 in many applications. Always confirm the specific property range your application needs before substituting, and check with your supplier's mill certificate.